PAGE 1 OF 2

Step 1. Mark a point at the high end of each gutter run, 1” from the top of the fascia. Snap chalk lines that slope toward downspouts. For runs longer than 35 ft., mark a slope from a high point in the center toward downspouts at each end.

Step 2. Install downspout outlets near the ends of gutter runs (at least one outlet for every 35 ft. of run). The tops of the outlets should be flush with the slope line, and they should align with end caps on the corners of the house, where drain pipes will be attached.

Step 3. Following the slope line, attach hangers or support clips for hangers for a complete run. Attach them to the fascia at 24” intervals, using deck screws.

Step 4. Following the slope line, attach outside and inside corners at all corner locations that don’t have end caps.